Dave Caswell (davec@apocalypse.org)
Wed, 30 Dec 1998 17:20:44 -0700
After upgrading to 2.2.0-pre1 from 2.1.132 my paralell port zip drive
isn't working. The printer, which is attatched to the same port,
still works fine. The kernel config was the same, I just ran 'make
oldconfig' and declined all the new options.
The relavent parts of the boot messages are:
<Linux argon 2.1.132 #1 Wed Dec 23 18:35:31 MST 1998 i586 unknown
>Linux argon 2.2.0-pre1 #2 Tue Dec 29 02:50:39 MST 1998 i586 unknown
=============
<ppa: Version 2.01
<ppa: Found device at ID 6, Attempting to use EPP 32 bit
<ppa: Found device at ID 6, Attempting to use PS/2
<ppa: Communication established with ID 6 using PS/2
<scsi0 : Iomega parport ZIP drive
<scsi : 1 host.
< Vendor: IOMEGA Model: ZIP 100 Rev: D.17
< Type: Direct-Access ANSI SCSI revision: 02
<Detected scsi removable disk sda at scsi0, channel 0, id 6, lun 0
<scsi : detected 1 SCSI disk total.
<sda : READ CAPACITY failed.
<sda : status = 0, message = 00, host = 0, driver = 28
<sda : extended sense code = 2
<sda : block size assumed to be 512 bytes, disk size 1GB.
>ppa: Version 2.01
>ppa: Found device at ID 6, Attempting to use EPP 32 bit
>ppa: Found device at ID 6, Attempting to use PS/2
>ppa: Unable to establish communication, aborting driver load.
>scsi : 0 hosts.
>scsi : detected total.
Has anyone already tracked this down?
Thanks,
davec
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 19:24:52 EST