[PARPORT] Installing Syquest EZ230


James Calvert (JMCalvert@infoscience.otago.ac.nz)
Thu, 13 May 1999 09:45:11 +1200


Hi

I realise this has been covered in the list archives but have'nt managed to
find similar examples.

Just want to know what exactly may be wrong with my installation. When
installing the pd driver I get the following errors (dmesg).

paride: version 0.94 installed
paride: epat registered as protocol 0
pda: epat 0.94, Shuttle EPAT chip c3 at 0x378, using mode 2 (8-bit)
pda: 6, 402653184 blocks [196608M], (13824/13824/13824), fixed media
 pda:pda: do_pd_read: status = 0x10100 = AMNF TMO
pda: do_pd_read_drq: status = 0x10100 = AMNF TMO
pda: do_pd_read_drq: status = 0x10100 = AMNF TMO
 unknown partition table

My Linux system is RedHat 5.1 and I just have a single device using the port
(EZ230).

Can anyone give me any tips/pointers etc

Thanks

James
*************************
    James Calvert

Research Assistant - SMRL
   University of Otago
      Dunedin, NZ
*************************

-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --



This archive was generated by hypermail 2.0b3 on Wed 12 May 1999 - 17:31:15 EDT