Kevin Turner (Kevin.Turner@oberlin.edu)
Sun, 28 Nov 1999 03:08:01 -0500
Device is a Microtek E3+
Using onscsi from ppSCSI-0.91.patch against 2.2.14pre9
scanimage is from debian package sane-gimp1.1 1.0.1-1999-10-21-6
There was a post from Brian Macy that says the E3+ scanner works "pretty well,"
but I'm not getting past "Invalid arguement" or at best, "Error during device
I/O".
Help on what fool thing I'm doing wrong is appreciated.
Also will be happy to provide more debugging output if that will help things
along.
# scanimage -v -d microtek:/dev/sg0
onscsi.3: Command to 6 (6): 12 0 0 0 60 0
onscsi.3: Command to 6 (6): 12 0 0 0 60 0
onscsi.3: Command to 6 (6): 12 0 0 0 60 0
onscsi.3: Command to 6 (6): 12 0 0 0 60 0
scanimage: open of device microtek:/dev/sg0 failed: Invalid argument
# scanimage -v -d microtek2:/dev/sg0
onscsi.3: Command to 6 (6): 12 0 0 0 5 0
onscsi.3: Command to 6 (6): 12 0 0 0 60 0
onscsi.3: Command to 6 (6): 12 0 0 0 5 0
onscsi.3: Command to 6 (6): 12 0 0 0 60 0
scanimage: open of device microtek2:/dev/sg0 failed: Error during device I/O
# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 06 Lun: 00
Vendor: Model: Scanner 300A4 Rev: 3.00
Type: Scanner ANSI SCSI revision: 02
# cat /proc/scsi/onscsi/0
ident: onscsi 0.90 (0.91), OnSpec 90c26
base port: 0x3bc
mode: 0
mode name: Nybble
delay: 1
nice: 0
verbose: 2
quiet: 0
tot_cmds: 406
tot_bytes: 25319
tot_errs: 0
# cat /proc/parport/0/hardware
base: 0x3bc
irq: none
dma: none
modes: SPP
also tried with:
# cat /proc/parport/0/hardware
base: 0x3bc
irq: 7
dma: none
modes: SPP,ECP,ECPPS2
but with same results
-- Kevin.Turner@oberlin.edu | OpenPGP encryption welcome here, see X-DSA-Key-- To unsubscribe, send mail to: linux-parport-request@torque.net -- -- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Sun 28 Nov 1999 - 03:11:30 EST