Re: [PARPORT] Ditto 2G "Device not configured"

• Previous message: Carlos Ferreyra: "Re: [PARPORT] Ditto 2G "Device not configured""
• In reply to: Carlos Ferreyra: "Re: [PARPORT] Ditto 2G "Device not configured""
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

On Tue, Feb 13, 2001 at 06:39:46AM -0300, Carlos Ferreyra wrote:

> The 0c3bc was a typo, I actually tried io=0x3bc, I also tried 0x378 (with the
> proper change of the bios).

The 'cannot get hardware' message is saying that the IO range is not
available, so are you sure you didn't make this mistake on the command
line? Take a look in /proc/ioports too.

I _think_ the message may also be triggered by not being able to get
an interrupt that's specified on the cmdline too.

Tim.
*/

• application/pgp-signature attachment: stored

-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --

• Next message: zeller: "[PARPORT] Programming the Parport"
• Previous message: Carlos Ferreyra: "Re: [PARPORT] Ditto 2G "Device not configured""
• In reply to: Carlos Ferreyra: "Re: [PARPORT] Ditto 2G "Device not configured""
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Feb 13 2001 - 06:12:34 EST