Hello,
My /var/log/messages reports the following, as I modprobe for paride, epat and pg:
[root@greymalkin /root]# modprobe paride
[root@greymalkin /root]# modprobe epat
[root@greymalkin /root]# modprobe pg
Mar 8 18:30:00 greymalkin CROND[1911]: (root) CMD ( /sbin/rmmod -as)
Mar 8 18:30:00 greymalkin kernel: paride: version 1.05 installed
Mar 8 18:30:03 greymalkin kernel: paride: epat registered as protocol 0
Mar 8 18:30:06 greymalkin kernel: pg: pg version 1.02, major 97
Mar 8 18:30:06 greymalkin kernel: pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 1 (5/3), delay 1
Mar 8 18:30:18 greymalkin kernel: pg0: HP CD-Writer+ 7200, slave
only...
[root@greymalkin /root]# cdrecord -scanbus
Cdrecord 1.9 (i686-pc-linux-gnu) Copyright (C) 1995-2000 Jörg Schilling
Using libscg version 'schily-0.1'
scsibus0:
cdrecord: Inappropriate ioctl for device. Cannot send SCSI cmd via ioctl
now, including any of the following modules hasn't helped me so far:
[root@greymalkin drivers]# ls scsi/
imm.o ppa.o sd_mod.o sg.o sr_mod.o
On my kernel (I am using 2.4.2 currently), I have:
ATA/IDE/MFM/RLL support --->
IDE, ATA and ATAPI Block devices --->
<*> SCSI emulation support
SCSI support --->
<*> SCSI support
<M> SCSI disk support
<M> SCSI CD-ROM support
<M> SCSI generic support
Block devices --->
<M> Parallel port IDE device support
<M> Parallel port IDE disks
<M> Parallel port ATAPI CD-ROMs
<M> Parallel port ATAPI disks
<M> Parallel port generic ATAPI devices
<M> Shuttle EPAT/EPEZ protocol
NOTE: I can mount a cdrom on the drive when using modprobe pcd instead of modprobe pg.
What may I be doing wrong???
Yours truly, rms
-- + No matter how much you do, you never do enough -- unknown + Whatever you do will be insignificant, | but it is very important that you do it -- Ghandi + So let's do it...?
-- To unsubscribe, send mail to: linux-parport-request@torque.net -- -- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Thu Mar 08 2001 - 13:38:05 EST