Blaise Gassend wrote:
>>How I can not acknowledge?
> The board you have connected to your parallel port connects the strobe and
> acknowledge pins, which acknowledges data as soon as it is output. By
> not having that connection, you wouldn't be acknowledging.
>>I checked, it works on some machines (generates square on pins - 0.5 Hz,
>>but not on this one with main board:
>>ECS K7S5AL (SIS735),SND,DDR+DIMM,LAN,ATX.
I have an ECS K7S5A motherboard (SiS735 chipset, No LAN). I can't get
the printer port on this board to work properley either. In DOS
however, the port works as I would expect.
I've pretty much given up on this parallel port under Linux, I guess the
Canon printer it was connected to wasn't at fault at all and shouldn't
have been smashed to pieces.
-- Regards, Robert Davidson. http://www.mlug.org.au/ IRC: puttputt, AustNet, #mlug
-- To unsubscribe, send mail to: firstname.lastname@example.org -- -- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Sat Apr 12 2003 - 04:46:09 EDT