Adrian Phillips (adrianp@powertech.no)
07 Feb 1998 16:00:39 +0100
** NOTE: email system just reconfigured - may be problemn !!
>>>>> "Scott" == Scott Gray <1sgray@preferred.com> writes:
Scott> Hi, I've just purchased a SyQuest SparQ. It probably won't
Scott> get to me till Tuesday (mail order). However, I'm trying
Scott> to go ahead and get the various patches that I will need to
Scott> use the SparQ with a Linux 2.0.33 kernel. I've already
Scott> applied the parport patch version 980103, enabled parport
Scott> support and recompiled my kernel. I've also downloaded and
Scott> compiled the latest version of the linux parallel port ide
Scott> devices patch "paride.tar.gz." I understand how to load
Scott> the the modules manually. I was wondering if there is a
Scott> way to get kerneld to realize that these modules exist and
Scott> to load them when necessary as opposed to loading them
Scott> manually with the insmod and rmmod. Also, where should I
Scott> place the modules? In other words, do I just place them
Scott> somewhere in my path or should I place them in a specific
Scott> location? Finally, I would greatly appreciate any
Scott> information that specifically relates to problems
Scott> associated with the SparQ.
I got autoloading of the modules working but dont - this is how I did it:
1) Compiled paride
2) Created a new directory /lib/modules/block and copied the paride
.os here (check your conf.mdoules file has the following lines:
path[fs]=/lib/modules
path[net]=/lib/modules
path[scsi]=/lib/modules
path[block]=/lib/modules
path[cdrom]=/lib/modules
path[ipv4]=/lib/modules
path[ipv6]=/lib/modules
path[misc]=/lib/modules
3) Run depmod -a to update the modules.dep files
4) Add the following lines to your conf.modules files: paride is
# loaded automatically by kerneld because modules.dep indicates that
# pd is dependent on it, but not epat because the driver does not
# necessarily use any particular protocol
alias block-major-45 pd
pre-install pd sh -c "insmod epat"
post-remove pd sh -c "rmmod epat; rmmod paride"
options pd verbose=1 drive0=0x378,0,0,5,1,1,0
# Change your options to whatever is necessary - check pd.c for more
# info.
5) Add the following lines (changing directory names as necessary) to
your /etc/fstab:
/dev/pda1 /ezflyer/ext2 ext2 defaults,noauto 0 0
I think this should do it - I tried it once but didnt bother because
although it can all be autoloaded it CANNOT (according to modprobe man
page) be auto unloaded - Question to the experts ? Does anyone know
what the feature mentioned in the man page is coming ? (Quote below)
Note that the pre- and post-remove commands will not be executed if a
module is "autocleaned" by kerneld! Look for the up-coming support
for per sistent module storage instead.
Hope this answers your question (on autoloading) - I dont have a Sparq
som dont know what problems there are
Adrian
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:17:25 EST