grant@torque.net
Wed, 19 May 1999 07:14:46 -0400 (EDT)
> The module was working a few days ago, however the system now freezes
> when insmod pg is issued. Don't recall doing something that may have
> affected it, however system was turned off without properly powering
> down (no shutdown, halt....) pg may have been loaded. Could that have
> done something? Anyhow, here is the debug info.
The improper shutdown should not have had any affect on future loading
of pg.
> May 18 12:08:11 localhost kernel: pg: pg version 1.02, major 97
> May 18 12:08:11 localhost kernel: pg0: Sharing parport0 at 0x3bc
> May 18 12:08:11 localhost kernel: pg0: epat 1.01, Shuttle EPAT chip c6
> at 0x3bc, mode 1 (5/3), delay 1
> May 18 12:09:47 localhost kernel: Unable to handle kernel paging request
> at virtual address c37df3da
> May 18 12:09:47 localhost kernel: current->tss.cr3 = 011a8000, %cr3 =
> 011a8000
> May 18 12:09:47 localhost kernel: *pde = 00000000
> May 18 12:09:47 localhost kernel: Oops: 0000
> May 18 12:09:47 localhost kernel: CPU: 0
> May 18 12:09:48 localhost kernel: EIP:
> 0010:[mpu401:unload_mpu401_R5febf284+326028/34308048]
Unfortunately, this doesn't tell us very much.
What version of the kernel are you using ? If you power _everything_
off and restart does this persist ?
--------------------------------------------------------------------------
Grant R. Guenther grant@torque.net
--------------------------------------------------------------------------
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 19 May 1999 - 07:16:15 EDT