Nitin Pande (firstname.lastname@example.org)
Thu, 27 May 1999 23:08:44 +0530
I've to control a stepper motor through the parallel port of a SGI indy
In IBM PC's the command outportb(port address, data) allows me to pass
the required data value to the port address.
In linux/unix how do i.
1. ascertain the port address of the parallel port
2. Send in the required data values to the port.
-- To unsubscribe, send mail to: email@example.com --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Thu 27 May 1999 - 13:39:08 EDT