Tim Waugh (tim@cyberelk.demon.co.uk)
Fri, 2 Jul 1999 16:33:57 +0100 (GMT)
On Fri, 2 Jul 1999, Jim Conner wrote:
> Yes I have that selected. Underneath it I have selected PC-style hardware
> as built-in. I do not have Support foreign hardware selected, however. Is
> there anything else I might not have bundled into the last compilation that
> you can think of?
I see. Do you get any log messages about parallel ports that have been
detected? It's starting to look like parport_pc hasn't found your port.
Which kernel did you say you were running, again?
Try booting with 'parport=0xBBB' on the command line, where 0xBBB is the
base address of your port. With 2.2.9/10, you should get a diagnostic
message about why it doesn't think there's a port there.
Tim.
*/
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Fri 02 Jul 1999 - 11:36:44 EDT