michael Goode (michael.goode@voila.fr)
Tue, 6 Jul 1999 17:56:07 +0200 (MET DST)
Hi everybody,
Is it possible to connect two PCs via a parallel port in mode EPP (I need
high speed transfer)?
To do that, one PC must be in a master mode and the other in a device mode.
I ask myself how to configure the device. If I use a parallel cable (without
any crossing), pins WRITE and DATA STROBE must be in INPUT and WAIT in
OUTPUT.
One solution would be to configure directly this pins in the parallel chip,
but I have no information about it. Is there another way to do it ?
I would like too to receive on IRQ (bit 4 of control register on). Does a
reception of a data generate automaticaly an IRQ ?
Thanks a lot
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Tue 06 Jul 1999 - 11:59:35 EDT