Douglas Danhour (ddanhour@soltec.net)
Wed, 12 Jan 2000 19:20:41 -0600
Hello,
I'm having a bit of a problem setting up my cdwriter (a parallel port HP
cdwriter+ 7500). It seems that I can access pcd0 as a normal cdrom, but
when trying to write to pg0, it complains that pg0 is not a device. The
enclosed attachment is a partial listing of dmesg:
How do I set up pg0 for writing?
Also, Can this cdwriter be set up as a scsi device? I have tried this
from the kernel and it usually prevents my zip drive from working
properly.
Any hints or suggestions welcomed.
Thanks,
D Danhour
ddanhour@soltec.net
hda: Maxtor 91010E6, ATA DISK drive
hdb: WDC AC38400L, ATA DISK drive
hdc: LTN301, ATAPI CDROM drive
hdd: IOMEGA ZIP 100 ATAPI, ATAPI FLOPPY drive
ide2: ports already in use, skipping probe
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: Maxtor 91010E6, 9541MB w/256kB Cache, CHS=1292/240/63
hdb: WDC AC38400L, 8063MB w/256kB Cache, CHS=1092/240/63
hdc: ATAPI 32X CD-ROM drive, 120kB Cache
Uniform CDROM driver Revision: 2.55
paride: epat registered as protocol 0
paride: epia registered as protocol 1
pcd: pcd version 1.07, major 46, nice 0
pcd0: Sharing parport0 at 0x378
pcd0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 5 (EPP-32), delay 1
pcd0: Slave: CD-Writer+ 7500
pg: pg version 1.02, major 97
pg0: Sharing parport0 at 0x378
pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 5 (EPP-32), delay 1
pg0: HP CD-Writer+ 7500, slave
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
sym53c416.c: Version 1.0.0
scsi : 0 hosts.
scsi : detected total.
Partition check:
hda: hda1 hda2 < hda5 > hda3
hdb: hdb1 < hdb5 > hdb2 hdb3
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 12 Jan 2000 - 20:26:36 EST