Tim Waugh a écrit :
> On Tue, Jun 13, 2000 at 01:50:05PM +0200, Dumas Patrice wrote:
>
> > It seems to be no problem with windows. I can't look at the cable as it is at
> > home, but is it possible that there is no problem with windows and still a
> > cable failure ?
>
> Can you try switching your parallel port setting in the CMOS to
> different options (SPP, EPP, etc) to see if it make a difference?
I swithed to SPP, and then cdrecord can see my cdr on the SCSI bus, with correct
identification. I haven't tried to burn a CD yet, but I don't see why it couldn't
run now.
Much thanks !
But then I have a problem, as I would like to have my printer in serie with my
external CDR, but when the bios is not in EPP mode, there is hardware problems,
the PC freeze, and then become unable to reboot, unless I open the box, take out
some cards and IDE connectors, boot then halt, and put all back (without the
printer on parallel port). The printer is a cannon BJC 2000. I haven't tried with
the two parallel devices in serie, but before I try, does someone know about my
kind of problem and how to overcome it ?
Pat
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Fri Jun 16 2000 - 06:11:31 EDT