On Jul 17, Tony Laszlo wrote:
>
> [...]
> I notice that the kernel source for 2.0.36
> doesn't have parport, parport_pc or plug
> and play modules.
>
> Is this kernel going to work with Trakker
> on the parallel port and ftape-4.x-doc-1.03 or
> must I go with 2.1.x?
It works, but you mustn't enable printer support (or only as module),
since sharing the parallel port doesn't work without parport. You
have to tell trakker the base address and irq. Add a line like this
to your /etc/conf.modules:
options trakker ft_fdc_base=0x378 ft_fdc_irq=7
Jochen
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Tue Jul 18 2000 - 04:14:06 EDT