Hello everybody
Tim Waugh wrote:
> On Sat, Jul 29, 2000 at 04:09:42PM +0800, Laurence John Oliver wrote:
>
> > insmode pt drive0=0x378,0 verbose=1
> [...]
> > '/lib/modules/2.2.16-3/misc/pt.o: init_module: Device or resource busy'
>
> Have a look at the output of dmesg. You could try with verbose=4 too.
>
> Tim.
I have installed now new trial beta distribution (Rdh62beta) with kernel
2.2.15 inside and I compiled kernel with options and modules correctly.
After that I restarted the machine and I launched the command "dmesg" that
you said after I did "modprobe imm command" . Then the miracle happened. I
found in the result of "demsg command" the lines below:
Releasing imm0
scsi : 1 host.
imm: Version 2.03 (for Linux 2.0.0)
imm: Found device at ID 6, Attempting to use EPP 32 bit
imm: Communication established with ID 6 using EPP 32 bit
scsi1 : Iomega VPI2 (imm) interface
scsi : 2 hosts.
Vendor: IOMEGA Model: ZIP 100 Rev: P.05
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi removable disk sdb at scsi1, channel 0, id 6, lun 0
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 196608 [96 MB] [0.1 GB]
sdb: Write Protect is off
sdb: sdb4
After this good news, I managed to mount my zip100 correctly with the command
line:
mount -t msdos /dev/sdb4 /zip100
It seems that recognition of zip100 device doesn't work correctly with kernel
version older than 2.2.14.
Thanks everybody
Bye
Marc
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Tue Aug 08 2000 - 19:18:37 EDT