On Thu, Jan 11, 2001 at 11:58:10AM -0800, David Guichard wrote:
> We've installed all the components to run a 5100C from the parallel
> port. We've patched a 2.2.16 kernel, installed SANE, ppscsi,
> epst. The program find-scanner finds the scanner. scanimage and
> xscanimage, however, don't find the scanner, even when told what
> device to use. After we attempt a scan, find-scanner no longer finds
> the scanner, but it starts working again if we unload epst.o and
> then reload it.
What settings are relevant to the parallel port in your BIOS (assuming
you're not using an add-on parallel port card)?
Tim.
*/
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Mon Jan 22 2001 - 10:51:48 EST