[PARPORT] HP 5100C: SMP isn't the only problem

From: Adam Warner (mailing_lists@consulting.net.nz)
Date: Fri Feb 23 2001 - 19:17:03 EST

  • Next message: RNBopp6768@aol.com: "[PARPORT] Re: HP 7200e: Inapropriate ioctl for device"

    Hi all,

    I don't get CPU lockups running as uni-processor but I am still getting these
    error messages when trying scanimage with the "--mode Color" option:

    epst.1: Command abort not supported
    epst.1: Bus reset

    The big difference is that I am still able to use the scanner after this
    happens compared to when I am in SMP mode.

    Has anyone else seen these "Command abort" messages when trying to copy in
    colour/grey with the epst module?

    Regards,
    Adam

    Here's the initialisation messages:0x378: FIFO is 16 bytes
    0x378: writeIntrThreshold is 16
    0x378: readIntrThreshold is 16
    0x378: PWord is 8 bits
    0x378: Interrupts are ISA-Pulses
    0x378: ECP port cfgA=0x10 cfgB=0x48
    0x378: ECP settings irq=7 dma=<none or set by other means>
    parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,COMPAT,EPP,ECP]
    parport0: irq 7 detected
    parport0: cpp_mux: aa55f00f52ad51(07)
    parport0: Found 1 daisy-chained devices
    parport1: PC-style at 0x278 [PCSPP,TRISTATE,EPP]
    parport1: cpp_daisy: aa5500ff(38)
    parport1: assign_addrs: aa5500ff(38)
    parport1: cpp_daisy: aa5500ff(38)
    parport1: assign_addrs: aa5500ff(38)
    ppSCSI 0.92 (0.92) installed
    epst.1: epst 0.92 (0.92), Shuttle EPST at 0x378 mode 2 (PS/2) dly 1 nice 0 sg
    16scsi1 : epst
      Vendor: HP Model: C5190A Rev: 3740
      Type: Processor ANSI SCSI revision: 02
    Detected scsi generic sg4 at scsi1, channel 0, id 0, lun 0, type 3
    epst.1: Command abort not supported
    epst.1: Bus reset

    -- To unsubscribe, send mail to: linux-parport-request@torque.net --
    -- with the single word "unsubscribe" in the body of the message. --

    This archive was generated by hypermail 2b29 : Fri Feb 23 2001 - 19:20:00 EST