[PARPORT] Example Code

• Previous message: Uwe Bonnes: "Re: [PARPORT] make lp driver use ECP mode"
• Next in thread: Tim Waugh: "Re: [PARPORT] Example Code"
• Reply: Tim Waugh: "Re: [PARPORT] Example Code"
• Reply: Peter Ryser: "Re: [PARPORT] Example Code"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hi all,

I am new to writing drivers and would like to see a few simple examples in
C so that I could write a parallel port driver (preferably kernel level)
to access some custom hardware of mine. I know the protocol (i.e. which
bits to set on which pins) in order to access my hardware and how to power
it up etc...

Also, I am using the 2.4 kernel.

Thank you very much.

-- 
Andrew Hogue
York University
Toronto, ON
CANADA
--  To unsubscribe, send mail to: linux-parport-request@torque.net --
--  with the single word "unsubscribe" in the body of the message. --

• Next message: Miroslav BENES: "Re: [PARPORT] Kernel 2.4.2 & Epat Shuttle HDD driver"
• Previous message: Uwe Bonnes: "Re: [PARPORT] make lp driver use ECP mode"
• Next in thread: Tim Waugh: "Re: [PARPORT] Example Code"
• Reply: Tim Waugh: "Re: [PARPORT] Example Code"
• Reply: Peter Ryser: "Re: [PARPORT] Example Code"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Mar 27 2001 - 18:54:26 EST