Re: [PARPORT] ftmt: /dev/qft0: Device not configured

• Previous message: Tim Waugh: "Re: [PARPORT] Problems reading ECR."
• In reply to: Fernando Ruza: "[PARPORT] ftmt: /dev/qft0: Device not configured"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

On May 25, Fernando Ruza wrote:
> Hi,
>
> I've installed ftape4.04a, I've loaded the modules:
> ftape, zftape, bpck-fdc and parport without any
> errors.
>
> [...]
>
> I have a HP Colorado 5GB tape device and a linux
> RedHat 6.2 with Kernel version 2.2.12-20.

This is an paride device, while ftape is for floppy based tape devices
(and their parallel port variants). Use the drivers from the paride
suit instead and tar to the /dev/pt0 device.

  Jochen

-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --

• Next message: Tim Waugh: "Re: [PARPORT] problems with parallel port card"
• Previous message: Tim Waugh: "Re: [PARPORT] Problems reading ECR."
• In reply to: Fernando Ruza: "[PARPORT] ftmt: /dev/qft0: Device not configured"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Fri May 25 2001 - 13:54:45 EDT