Arild Hestvik (hestvik@ruccs.rutgers.edu)
Sun, 03 May 1998 10:55:24 -0400
I insmod the paride and epat modules successfully, but when
I do insmod pd, it can't find the correct port number (which I think
is 378). Can anyone help me?
-Arild
--------------------------------------------------
from dmesg:
paride: version 0.94 installed
paride: epat registered as protocol 0pda: epat: port 0x3bc, mode 0, ccr
ff, test=(255,255,510)
pda: epat: port 0x3bc, mode 1, ccr ff, test=(255,255,510)
pda: epat: port 0x3bc, mode 2, ccr ff, test=(255,255,510)
pda: epat: port 0x278, mode 0, ccr ff, test=(255,255,510)
pda: epat: port 0x278, mode 1, ccr ff, test=(255,255,510)
pda: epat: port 0x278, mode 2, ccr ff, test=(255,255,510)
pda: epat: port 0x278, mode 3, ccr ff, test=(255,255,510)
pda: epat: port 0x278, mode 4, ccr ff, test=(255,255,510)
pda: epat: port 0x278, mode 5, ccr ff, test=(255,255,510)
pda: epat: port 0x268, mode 0, ccr ff, test=(255,255,510)
pda: epat: port 0x268, mode 1, ccr ff, test=(255,255,510)
pda: epat: port 0x268, mode 2, ccr ff, test=(255,255,510)
pda: epat: port 0x268, mode 3, ccr ff, test=(255,255,510)
pda: epat: port 0x268, mode 4, ccr ff, test=(255,255,510)
pda: epat: port 0x268, mode 5, ccr ff, test=(255,255,510)
pda: epat: port 0x27c, mode 0, ccr ff, test=(255,255,510)
pda: epat: port 0x27c, mode 1, ccr ff, test=(255,255,510)
pda: epat: port 0x27c, mode 2, ccr ff, test=(255,255,510)
pda: epat: port 0x26c, mode 0, ccr ff, test=(255,255,510)
pda: epat: port 0x26c, mode 1, ccr ff, test=(255,255,510)
pda: epat: port 0x26c, mode 2, ccr ff, test=(255,255,510)
pda: Autoprobe failed
pd: no valid drive found
paride-0.94#
-- Rutgers Center for Cognitive Science (RuCCS) Rutgers University, Busch Campus Psychology Building Addition New Brunswick, NJ 08903-- To unsubscribe, send mail to: linux-parport-request@torque.net -- -- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:17:41 EST