Michel G. Breitfellner, ESA/VILSPA, SAI, Tel.+34 1 8131318 (mbreitfe@iso.vilspa.esa.es)
Tue, 1 Dec 1998 14:12:18 +0100
Dear Grant,
Following your advise I changed the parallel port setting. The DOS hardware
setup programme that came with my Toshiba 660CDT notebook leaves me only with
the choice between "ECP" or "standard bidirec." So I switched to "std. bidir.".
Unfortunately I still cannot force the delay to 0 and every intent to write a
cd still terminates with the same error (see below). What I'm doing wrong?
Best regards,
Michel
_______________________________________________________________________________
> insmod paride
> insmod epat
> insmod pg drive0=0x378,0 verbose=1
> dmesg:
paride: version 1.02 installed
paride: epat registered as protocol 0
pg: pg version 1.01s, major 97
pg0: epat: port 0x378, mode 0, ccr 0, test=(255,0,0)
pg0: epat: port 0x378, mode 1, ccr 40, test=(255,224,448)
pg0: epat: port 0x378, mode 2, ccr 0, test=(255,0,0)
pg0: epat: port 0x378, mode 3, ccr ff, test=(255,255,510)
pg0: epat: port 0x378, mode 4, ccr ff, test=(255,255,510)
pg0: epat: port 0x378, mode 5, ccr ff, test=(255,255,510)
pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 2 (8-bit), delay 1
pg0: Reset (1001) signature = ff ff ff ff ff (incorrect)
pg0: Reset (1) signature = 1 1 1 14 eb
pg0: HP CD-Writer+ 7200, slave
> ./cdrecord -v -dummy speed=1 dev=0,0 /home/cdrw/home.img
Cdrecord release 1.6.1 Copyright (C) 1995-1998 Jvrg Schilling
TOC Type: 1 = CD-ROM
scsidev: '0,0'
scsibus: 0 target: 0 lun: 0
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 1
Vendor_info : 'HP '
Identifikation : 'CD-Writer+ 7200 '
Revision : '3.01'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : SWABAUDIO
Track 01: data 553 MB
Total size: 636 MB (63:00.77) = 283558 sectors
Lout start: 636 MB (63:02/58) = 283558 sectors
Current Secsize: -1
./cdrecord: Drive needs to reload the media to return to proper status.
ATIP start of lead in: -11625 (97:27/00)
ATIP start of lead out: 333750 (74:12/00)
Disk type unknown
Manufacturer: Old Ritek Co.???
Blocks total: 333750 Blocks current: 333750 Blocks remaining: 50192
RBlocks total: 336246 RBlocks current: 336246 RBlocks remaining: 52688
Starting to write CD/DVD at speed 1 in dummy mode for single session.
Last chance to quit, starting dummy write in 1 seconds.
Waiting for reader process to fill input-buffer ... input-buffer ready.
Starting new track at sector: 0
./cdrecord: Input/output error. write_g1: scsi sendcmd: retryable error
CDB: 2A 00 00 00 06 B0 00 00 10 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 03 00 00 00 00 19 00 05 9B 52 0C 09 00 00 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x09 (write error - loss of streaming) Fru 0x0
Sense flags: Blk 0 (valid)
cmd finished after 0.689s timeout 40s
write track data: error after 3506176 bytes
Sense Bytes: F0 00 00 00 00 00 00 19 00 05 A0 14 00 00 00 00 00 00
Writing time: 22.805s
Fixating...
WARNING: Some drives don't like fixation in dummy mode.
Fixating time: 169.531s
./cdrecord: fifo had 235 puts and 108 gets.
./cdrecord: fifo was 0 times empty and 2 times full, min fill was 34%.
_______________________________________________________________________________
> insmod paride
> insmod epat
> insmod pg drive0=0x378,0,0,-1,-1,0 verbose=2
/lib/modules/2.0.35/misc/pg.o: init_module: Device or resource busy
> dmesg:
pg: pg version 1.01s, major 97
pg0: epat: port 0x378, mode 0, ccr 0, test=(255,255,510)
pg0: epat: port 0x378, mode 1, ccr 40, test=(255,255,510)
pg0: epat: port 0x378, mode 2, ccr ff, test=(255,255,510)
pg0: epat: port 0x378, mode 3, ccr ff, test=(255,255,510)
pg0: epat: port 0x378, mode 4, ccr ff, test=(255,255,510)
pg0: epat: port 0x378, mode 5, ccr ff, test=(255,255,510)
pg0: Adapter not found
pg: No ATAPI device detected
_______________________________________________________________________________
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:18:49 EST