Dong Liu (dliu@npiww.com)
Tue, 8 Dec 1998 20:05:41 -0500 (EST)
Hi,
>From the information I gothered from linux parallel ide web side, the
HP CD writer 7200e is supported, but I can't get it work. This is what
I have done:
Compiled paride, pg, pcd all as modules, then
insmod paride
insmod epat
insmod pg drive0="0x378,0,0,-1,-1,0"
kernel displayed
Dec 8 16:09:39 yangtze kernel: pg0: Sharing parport0 at 0x378
Dec 8 16:09:39 yangtze kernel: pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 0 (4-bit), delay 0
Dec 8 16:09:41 yangtze kernel: pg0: HP CD-Writer+ 7200, slave
Then I got cdrecord-1.8 compiled, then tried it as
cdrecord dev=/dev/pg0 -inq
I got
Cdrecord release 1.8a14 Copyright (C) 1995-1998 Jörg Schilling
scsidev: '/dev/pg0'
devname: '/dev/pg0'
scsibus: -2 target: -2 lun: -2
/opt/schily/bin/cdrecord: Not a typewriter. Cannot open SCSI driver.
What I did wrong?
Thanks
Dong.
BTW, my kernel is 2.1.131 unpatched.
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:18:52 EST