grant@torque.net
Tue, 8 Dec 1998 21:05:09 -0500 (EST)
> From the information I gothered from linux parallel ide web side, the
> HP CD writer 7200e is supported, but I can't get it work. This is what
> I have done:
>
> Compiled paride, pg, pcd all as modules, then
>
> insmod paride
> insmod epat
> insmod pg drive0="0x378,0,0,-1,-1,0"
>
> kernel displayed
>
> Dec 8 16:09:39 yangtze kernel: pg0: Sharing parport0 at 0x378
> Dec 8 16:09:39 yangtze kernel: pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 0 (4-bit), delay 0
First problem: your parallel port is set to SPP or ECP mode. Please
try to set it into EPP mode. You want to see mode 5, not mode 0.
> Dec 8 16:09:41 yangtze kernel: pg0: HP CD-Writer+ 7200, slave
>
> Then I got cdrecord-1.8 compiled, then tried it as
Hmm. I don't know anything about 1.8 (yet) try 1.6.1 and be sure to
compile in support for PG.
--------------------------------------------------------------------------
Grant R. Guenther grant@torque.net
--------------------------------------------------------------------------
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:18:52 EST