Dan Lilliehorn (dl@dl.nu)
Tue, 9 Mar 1999 14:35:17 +0100 (CET)
> Did you remember to remove the append statement from your lilo.conf ? ;-)
>
> Probably not, since the delay is still zero. The append statement
> I gave you forced the mode to 2, so the drive did not attempt to probe
> for the EPP modes.
>
> Remove the pg.drive0= stuff and see whether testport's idea of EPP mode
> satisfies the epat driver ...
That's it!!
dmesg:
paride: version 1.02 installed
paride: epat registered as protocol 0
pg: pg version 1.02s, major 97
pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 5 (EPP-32), delay 1
pg0: HP CD-Writer+ 7200, slave
should I set the delay to 0 anyway or is 1 ok?
Is there NO way to do this without the assistance of xDOSemu? It's not
that big of a deal, but rather annoying. Not very transparent... anyway,
now I'll try burning again. Thanks!
/dl
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Tue 09 Mar 1999 - 08:37:35 EST