Abhishek Kumar (email@example.com)
Sat, 29 May 1999 22:49:44 +0000
I am trying to write a parallel port driver for data aquisition from
an ADC. I have a few questions (basic) and would be grateful if anyone
can answer them.
1. Which high and low level modules do I load in order to get my ECP
port (on a laptop running 2.0.36, using paride) working?
2. Am I better off using inb and outb instead of writing a driver.
3. Is there is any existing code that I can adapt for my use?
I dont want to really use the newer kernels as the APM does not work.
-- To unsubscribe, send mail to: firstname.lastname@example.org --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Sat 29 May 1999 - 22:47:36 EDT