grant@torque.net
Mon, 19 Jul 1999 08:20:53 -0400 (EDT)
> Hi! I have a HP7200e CD that connects via the parallel port.
> I just compiled the modules. This the message that is on the console:
>
> paride: version 1.04 installed
> paride: epat registered as protocol 0
> pg: pg version 1.02, major 97
> pg0: Sharing parport0 at 0x378
> pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 2 (8-bit), delay 1
> pg0: HP CD-Writer+ 7200, slave
>
> I suppose that everything is ok, but now how can I begin to copy CDs?
>
> I downlaoaded gtoaster from linuxberg, but I dunno how to use it.
>
> What do you recommend me to use?
The official answer is "cdrecord" but apparently gcombust also works
(I assume it runs on top of cdrecord).
NB: you won't actually succeed in burning with your current parallel port
settings. Check out
http://www.torque.net/parport/cdr.html
--------------------------------------------------------------------------
Grant R. Guenther grant@torque.net
--------------------------------------------------------------------------
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Mon 19 Jul 1999 - 08:21:41 EDT