On Mon, Apr 17, 2000 at 03:40:25PM +0800, zhu qun ying wrote:
> Hi, I am implementing a parallel port on a StrongARM board (silmilar
> to LART) with its GPIO pins. At this stage I have done most (without
> testing yet) of the low level fucntions, but I am not sure what base
> address to choose from for parport_register_port()? Could I use the
> PC style address? When will the translation happens? What do I need
> to takle care?
When you are implementing a port driver (like parport_pc), you can put
anything you find useful there. Your driver should be the only thing
that tries to interpret it.
Tim.
*/
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2b29 : Mon Apr 17 2000 - 07:15:07 EDT