AW: [PARPORT] Paride, epat, pg todo funciona pero no se ve el CDr

From: Norman.Dannhoff@Bertelsmann.de
Date: Wed Oct 24 2001 - 03:00:08 EDT

  • Next message: Tim Waugh: "[PARPORT] cdrecord/sg/bpck6 problem"

    Hi Rainer,
    you can use dmesg for examining the load process of your modules. epat might
    not be the correct protocol for a Mitsumi. Try to load all protocols before
    loading pg. pg will automatically detect the correct one - and make sure
    that your parallel port runs in EPP mode.

    Regards,
    Norman

    -----Ursprüngliche Nachricht-----
    Von: Gross Trebut, Rainer [mailto:Rainer.Gross@sonda.com]
    Gesendet: Dienstag, 23. Oktober 2001 19:04
    An: 'linux-parport@torque.net'
    Betreff: [PARPORT] Paride, epat, pg todo funciona pero no se ve el CDr

    Hi all!

    I am running a SuSE Linux 7.2 kernel version 2.4.4
    on a Compaq Presario 1246 Notebook
    I do also have a Mitsui CDR which is installed in a
    Paralellport IDE adapter case.

    The CDr is doing fine with Windows (but I am not).

    So my problem is that I was able to install all modules

    modprobe paride
    modprobe epat
    modprobe pg

    and non of them reported an error or any other problem.
    But neither they reported a successfull connection.

    And all pgX devices don't work.

    Could anyone tell me what could be the problem or at least
    if there is any log were probably some misbehavier is loged?

    Thanks in advance

    Rainer

    -- To unsubscribe, send mail to: linux-parport-request@torque.net --
    -- with the single word "unsubscribe" in the body of the message. --

    -- To unsubscribe, send mail to: linux-parport-request@torque.net --
    -- with the single word "unsubscribe" in the body of the message. --

    This archive was generated by hypermail 2b29 : Wed Oct 24 2001 - 03:05:27 EDT