Patrick Bauer (bauerp@niagara.com)
Tue, 19 May 1998 19:39:30 -0400 (EDT)
well... maybe i should get this add-on parallel card exchanged for another
one... looking at the card... it's a no-name card... without the name of
the manufacturer anywhere... but on the card... it says ECC/EPP... and
TC020... which i guess is the model number for a single port card... there
is room for another chip... and jumpers... so i guess this is the single
port version..
the chip is..
Holtek
HT6535
9747F1891
and on the parallel connector... is written TTN 995346... but i think that
is some kind of warranty number..
it is possible... that there was some sort of IRQ conflict... or address
conflict... but i made sure the i/o addresses... and interrupts... of both
parallel ports... were different... and that there were no conflicts..
Pat.
On Tue, 19 May 1998, Grant R. Guenther wrote:
> > Actually... i've tried this with two different motherboards... one with
> > with a Tx-Pro chipset... a.k.a. ALI Alladin IV... with an AMI BIOS... and
> > a DFI motherboard with an Intel TX chipset... with an Award Bios... same
> > problems on both... so i just have to conclude that a parallel scanner...
> > and a SparQ parallel drive... will simply not work together if they are
> > attached to two seperate parallel ports
>
> Or, the add-in parallel port is doing something bad. Can you identify
> the manufacturer of the board and/or the adapter chip ?
>
> --------------------------------------------------------------------------
> Grant R. Guenther grant@torque.net
> --------------------------------------------------------------------------
>
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:17:46 EST