Gianandrea Rigoni (gianone@yahoo.com)
Mon, 6 Jul 1998 00:05:52 -0700 (PDT)
Hello!
thanks everybody for the quick answers!
---grant@torque.net wrote:
>
> Why did you change the speed without doing a -dummy test first ?
>
I was in a hurry...
I tested only for 1x...
> The clues are all here:
>
> > Sense Code: 0x0C Qual 0x09 (write error - loss of streaming) Fru 0x0
>
> > pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 0 (4-bit),
delay 1
>
> The problem is that you have either an old SPP port or a modern port
set
> to ECP mode. Check your CMOS settings and set the port into EPP mode.
My parallel port is set on EPP (ppa driver is working with epp 1.9)
>
> You can burn CDs at 1x in the SPP modes (0-2) but for 2x burning you
need
> an EPP mode (3-5).
All my excuses for my laziness on reading the .c .h files. I had few
time for everything and since I got the burner working, I made 3/4 CD
at 1x before trying 2x, I had to make a backup of the HD's so fast I
could...
best regards
Gianandrea
--------------------
Gianandrea Rigoni
_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:17:55 EST