Dong Liu (dliu@npiww.com)
Tue, 8 Dec 1998 23:03:21 -0500 (EST)
grant@torque.net writes:
> > insmod pg drive0="0x378,0,0,-1,-1,0"
> >
> > kernel displayed
> >
> > Dec 8 16:09:39 yangtze kernel: pg0: Sharing parport0 at 0x378
> > Dec 8 16:09:39 yangtze kernel: pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 0 (4-bit), delay 0
>
> First problem: your parallel port is set to SPP or ECP mode. Please
> try to set it into EPP mode. You want to see mode 5, not mode 0.
>
It is a Compaq Deskpro 2000, I couldn't find how to set the parport
mode in BIOS setup.
> > Dec 8 16:09:41 yangtze kernel: pg0: HP CD-Writer+ 7200, slave
> >
> > Then I got cdrecord-1.8 compiled, then tried it as
>
> Hmm. I don't know anything about 1.8 (yet) try 1.6.1 and be sure to
> compile in support for PG.
>
Tried 1.6.1, seem result. is "cdrecord dev=/dev/pg0 -inq" the correct
way to test it?
Dong
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:18:52 EST