Michele Bini (email@example.com)
Wed, 16 Jun 1999 19:36:35 +0000
On Tue, Jun 15, 1999 at 07:21:16PM -0400, firstname.lastname@example.org wrote:
> > When i load the onscsi-module i get the following information out:
> > onscsi.1: onscsi 0.90 (0.90), OnSpec 90c26 at 0x378 mode 0 (Nybble) dly 1
> You may wish to check the CMOS settings for your parallel port. Try to
> get it into EPP mode. Anything else will be painful. onscsi should report
> mode 4 if you get into EPP mode.
FYI, here scanning seems to work fine even when not in EPP mode.
-- To unsubscribe, send mail to: email@example.com --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 16 Jun 1999 - 13:39:53 EDT