Re: [PARPORT] SuperIO Support

From: Gunther Mayer (Gunther.Mayer@t-online.de)
Date: Wed Dec 04 2002 - 11:24:34 EST

Next message: Vadim Kovalev: "[PARPORT] Please help with PPP over direct parallel cable connection."

Previous message: Keith Winstein: "[PARPORT] 2.7 MHz TTL Input (2.7 megabytes/sec) With PCI Parallel Port?"
In reply to: Chris Shaw: "[PARPORT] SuperIO Support"
Next in thread: Nate: "Re: [PARPORT] SuperIO Support"
Reply: Nate: "Re: [PARPORT] SuperIO Support"
Reply: Chris Shaw: "Re: [PARPORT] SuperIO Support"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Chris Shaw wrote:
>
> I was just wondering which SuperIO Chipsets the current parport code
> supports. I have a GigaByte board which uses an ITE IT8705F SuperIO.

When I load parport_pc, everything seems fine, the IO/IRQ/DMA and
> settings are detected but no data will come through the port. When I do a:
>
> # cat /dev/lp0 (After loading lp.o of course :) )
>
> I get:
>
> lp0: Input/Output Error...
>
> I'm not sure how to correct this, I have tried putting it in all modes
> (Polling/Interrupt/Software) but nothing seems to work...

You missed
insmod lp

-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --

Next message: Vadim Kovalev: "[PARPORT] Please help with PPP over direct parallel cable connection."
Previous message: Keith Winstein: "[PARPORT] 2.7 MHz TTL Input (2.7 megabytes/sec) With PCI Parallel Port?"
In reply to: Chris Shaw: "[PARPORT] SuperIO Support"
Next in thread: Nate: "Re: [PARPORT] SuperIO Support"
Reply: Nate: "Re: [PARPORT] SuperIO Support"
Reply: Chris Shaw: "Re: [PARPORT] SuperIO Support"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Wed Dec 04 2002 - 10:24:02 EST