Thomas Good (tomg@nrnet.org)
Fri, 23 Oct 1998 08:25:14 -0400 (EDT)
Hi...following the ftape discussion for awhile, perusing the torque
webpage, etc...but am still befuddled!
I had a conner 800MB tape drv fall into my lap. She runs off the
parallel port just dandy in dos so the device is operational.
However, I am confused as to what driver to use. The ftape docs
say that ftape/mt don't support parallel port streamers, only
internals. And - I don't see my conner listed amongst the devices
supported by paride...
Any tips as to what I am missing here most welcome.
Also, can someone give me a link to where I can grab the latest ver
of paride (not patches, the src itself...)
Many thanks!
Tom
----------- Sisters of Charity Medical Center ----------
Department of Psychiatry
----
Thomas Good, System Administrator <tomg@q8.nrnet.org>
North Richmond CMHC/Residential Services Phone: 718-354-5528
75 Vanderbilt Ave, Quarters 8 Fax: 718-354-5056
Staten Island, NY 10304 www.panix.com/~ugd
----
Powered by PostgreSQL 6.3.2 / Perl 5.004 / DBI-0.91::DBD-PG-0.69
-- To unsubscribe, send mail to: linux-parport-request@torque.net --
-- with the single word "unsubscribe" in the body of the message. --
This archive was generated by hypermail 2.0b3 on Wed 30 Dec 1998 - 10:18:39 EST